No heat? Same-day furnace repair across Douglas County · Call (720) 964-2178 Diagnostic $85, credited toward your repair · Free replacement estimates

AC Repair

Fast, Reliable AC Repair in Douglas County, CO

Your AC shouldn't fail when you need it most. Our certified techs fix any cooling issue fast, with honest pricing — and if a repair isn't done right, we come back and fix it free.

  • Same-day & next-day appointments
  • No hidden fees, honest upfront pricing
  • EPA 608 Universal certified technicians
  • Not fixed right? We come back free

Diagnostic visit $85 — credited toward your repair • Same-day service often available

4.9 out of 5 · 111 Google reviews
Smart Lion technician repairing a central air conditioner
Done-right guaranteeNot fixed right? We come back free

1. AC is blowing warm air (no cooling at all)

If your air conditioner is blowing warm air, the system has completely lost its cooling capability. This usually indicates a failure of one of the critical components.

Main causes

1. The outdoor unit (condenser) is not running at all

This is the most common electrical issue in central AC systems.

Symptoms:

  • outdoor fan not spinning
  • compressor silent — no humming, no vibration
  • only the indoor blower runs
  • no “click” from the contactor when the system turns on

Typical electrical causes:

  • blown fuse in the disconnect box
  • failed contactor — burnt or stuck contacts
  • failed dual capacitor — prevents both the fan motor and compressor from starting
  • bad hard-start kit or failed start relay
  • damaged or corroded wiring
  • control board surge damage after a thunderstorm

If the outdoor unit doesn't start, cooling will not begin, no matter how long the system runs.

2. No refrigerant (leak in the system)

A refrigerant leak causes pressure to drop. As a result the evaporator coil cannot absorb heat and the airflow remains warm.

Most common leak locations: the evaporator coil, flare fittings, and the copper line set (vibration wear).

3. Frozen evaporator coil

When the coil is covered in ice, it cannot cool air.

Causes: clogged air filter, restricted airflow, dirty evaporator coil, low refrigerant.

Symptoms: weak airflow, warm air, ice on the large copper suction line.

4. Compressor failure

One of the most expensive and serious breakdowns.

How to recognize compressor failure:

  • outdoor fan runs, but there is no cooling
  • loud humming or clicking when the compressor tries to start
  • compressor won't start even with a hard-start kit
  • excessively high LRA (locked rotor amps)
  • compressor overheats and shuts off on thermal overload

Common reasons for compressor failure: overheating due to a dirty condenser, old age (10–15 years is typical for Colorado), short cycling, and running the system with low refrigerant.

Our solutions

  • Restore power, inspect fuses and contactor
  • Replace the dual capacitor
  • Repair damaged wiring
  • Perform leak test, repair and recharge
  • Defrost and clean the evaporator coil
  • Full compressor diagnostics (amperage, resistance, load)
  • Repair or rebuild the outdoor unit

2. AC is cooling, but not enough (weak cooling performance)

In this situation, the AC does cool but not well enough — the house warms up during the day, the temperature rises above the thermostat setting, or cooling is very slow. This is a problem of efficiency, not a total system failure.

Main causes

1. Dirty outdoor condenser coil

If the condenser is clogged with cottonwood, dirt, grass, or construction dust, it loses up to 40% of its cooling capacity.

Symptoms: hot air blowing out of the outdoor unit, outdoor fan running but the home not cooling, higher electricity bills, compressor overheating.

Colorado has a lot of cottonwood and dust — this problem is extremely common.

2. Poor airflow inside the home

Reasons: weak blower motor, clogged or crushed ductwork, closed or blocked supply vents, dirty evaporator coil.

Symptoms: low airflow, cold air at the vent but not enough of it, uneven cooling between rooms.

3. Low refrigerant (leak in the system)

A refrigerant leak causes pressure to drop: the evaporator coil cannot absorb heat, airflow stays warm, and the system may freeze up. Most common leak locations are the evaporator coil, flare fittings, and the copper line set (vibration wear).

4. Overheating or weakening compressor

A compressor that is wearing out still runs, but produces less cooling.

Symptoms: slow cooling, the house barely cools during the day, cooling only improves at night, long run times. This is a “weak compressor,” not a fully failed one.

Our solutions

  • Deep cleaning of the outdoor condenser
  • Blower motor diagnostics
  • Compressor performance test
  • Perform leak test, repair and recharge

Reviews

What homeowners say about us

4.9 out of 5 · 111 Google reviews

“These guys are the best. They show up quickly and get to the source of the issue.”
Randy S. · Google review
“Vadim was very honest and thorough. We appreciate the professionalism.”
Patrick M. · Google review
“Excellent customer service, response time and technical know how. Well done!”
Mike S. · Google review
“Quick and effective and reasonable cost. Cannot ask for better.”
Richard L. · Google review

Read all 111 reviews on Google

Talk to an HVAC specialist now

Whether you need an urgent repair, a routine tune-up, or a full system replacement, our team is ready to deliver fast, reliable service.